Herunterladen Inhalt Inhalt Diese Seite drucken

Telecom Behnke 20-0013 Anleitung Seite 55

Elektronik-erweiterung sprache/display/echtzeituhr
Vorschau ausblenden Andere Handbücher für 20-0013:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Code
Parameter
The first cypher determines the voice message to be played prior to di-
alling the telephone number, e.g. a message like "Direct call activated".
The second cypher determines the voice message to be played repea-
tedly while the connection is being established, e.g. a message like
"Please hold the line." The third cypher determines the voice message
to be played upon picking up by the called party. This message will also
only be played to the called party, e.g. a message like "Call from your
intercom system." or information with regard to the caller's position
when used as an emergency phone. This configuration step will affect
all direct calls including calls via speed dialling and calls from the
telephone book.
Example: Provided that you recorded the following voice messages
via configuration step code 51:
1. Voice message no. 1 (51-1): "Direct call activated."
3. Voice message no. 3 (51-3): "Please hold the line."
6. Voice message no. 6 (51-6): "Call from your intercom system."
Making the following entry will result in these messages being played
during a direct call:
58 1 [beep] 5 [beep] 6 [beep] #
In case the message "Direct call activated." should not be played,
make the following entry.
58 0 [beep] 5 [beep] 6 [beep] #
Voice message and the ### function:
59
0 = No voice message
1 = Play voice message no. 1
9 = Play voice message no. 9
10 = Play the same message that was played after the last time the
receiver was picked up
Via this configuration step you may set a voice message to be played
when the DTMF sequence # # # is entered within 5 seconds during a
connected call.
To set-up a connected Display Module use configuration step codes 60 to 69. As Display mo-
dule configuration only makes sense with the Electronics Add-On Voice / Display / Real Time
Clock installed, the corresponding configuration steps (with the exception of "Reset Display
Module") are only accessible in case an Electronics Add-On Voice / Display / Real Time Clock
is actually installed. You need an additional 12 V power supply to run it.
www.behnke-online.com
Instructions Electronic Add-On Voice / Display / Real Time Clock
Configurations and Set-up
Confirmation
Default setting: 10
#
#
#
#
GB
55

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

20-001420-000120-004120-0043

Inhaltsverzeichnis