Table Of Configuration Steps - Telecom Behnke 20-0013 Anleitung

3.2. Table of Configuration Steps

Code Parameter
Telephone number:
21 Telephone number
22 Telephone number
23 Telephone number
MLM)
24 Telephone number
MLM)
25 Telephone number telephone number 5 (button 5)
26 Telephone number telephone number 6 (button 6)
27 Telephone number telephone number 7 (button 7)
28 Telephone number telephone number 8 (button 8)
29 Telephone number telephone number 9 (i key on the number keypad)
Telephone numbers consist of cyphers only and may be up to 20 cha-
racters long. You may enter the following special symbols in connection
with telephone numbers:
*0 = dial *
*1 = dial #
*2 = pause for 2 seconds
*3 = wait for dial tone
With version 1.30 or later:
*4x Condition
x=0 Always
x=1 Current time within schedule 1
x=2 Current time within schedule 2
x=3 Current time not within schedule 1
x=4 Current time not within schedule 2
x=5 For technical alarm
x=6 For non-technical alarm
x=7 If alarm entry is enabled
x=8 If alarm entry is disabled
x=9 Else (only makes sense with other *4x conditions having been
set)
*5x Play message no. x
*50 Play signal sequence
*6x Display text no. x (only makes sense with a display module in use)
*7x Activate relays (1=Relay 1, 2=Relay 2, 3=Relays 1&2)
*8xy Wait for the call to be answered (x=voice message to be played while
(1)
only makes sense with configurations step 17>0
waiting for the call to be answered and y=voice message to be played
after the call has been answered)
www.behnke-online.com
Instructions Electronic Add-On Voice / Display / Real Time Clock
telephone number 1 (button 1) (integrated MLM with
V1.34 or later)
telephone number 2 (button 2) (integrated MLM)
telephone number 3 (button 3) (MLM B / integrated
telephone number 4 (button 4) (MLM C / integrated
(1)
(1)
(1)
(1)
Configurations and Set-up
Confirma-
tion
default: cf. text
#
#
#
#
#
#
GB
45