Telecom Behnke 20-0013 Anleitung Seite 47

Code Parameter
With version 1.52 or later:
*7** Establish an IP video connection to the dialled telephone
number (*7** needs to be entered after the telephone
number dialled)
*78 Enables additional relay 1 (only makes sense with relay 2
operations mode set to 23 and a connected additional relay board)
*79 Enables additional relay 2 (only makes sense with relay 2
operations mode set to 23 and a connected additional relay
board)
By default, no telephone numbers are predefined.
Real Time Clock Reset:
40 ****
When performing a reset, the configuration steps 41 to 49 will return
to their default setting.
Enter time and date:
40 Time [beep] date [beep]
Enter the current time as hours (=HH) and minutes (=MM) using the
format HHMM, e.g. 0815 for 8.15 am. Enter today's date as day (=DD),
month (=MM) and year (=YY) using the format DDMMYY. Your entry
should have the following structure:
HHMM [beep]
Time
Example:
Time: 8:15 am Date: April 8, 2014
0815 [beep] 080414 [beep] #
Example:
Time: 10:05 am Date: remains unchanged
1005 [beep] #
Please note: Upon entering an invalid time
(e.g. 2930) or upon entering an invalid date (e.g. 3002) an error tone
will be played while time and date remain unchanged. Entering a time
code without a date is only possible with a valid date saved to the
Electronics Add-On, i.e. a valid date has been set before. Time-cont-
rolled functions are only available with valid time and date informati-
on saved to the Electronics Add-On. In case time and date information
is lost, e.g. due to battery problems or an extremely potent interfe-
rence, it is no longer possible to use the time-controlled functions.
www.behnke-online.com
Instructions Electronic Add-On Voice / Display / Real Time Clock
DDMMYY [beep] #
Date
Configurations and Set-up
Confirmation
#
#
GB
47