Telecom Behnke 20-0013 Anleitung Seite 52

Instructions Electronic Add-On Voice / Display / Real Time Clock
GB GB
Configurations and Set-up
Code Parameter
Record a voice message:
51 1 = Record voice msg. no. 1 (short msg.) 4 s
2 = Record voice msg. no. 2 (short msg.) 4 s
3 = Record voice msg. no. 3 (short msg.) 4 s
4 = Record voice msg. no. 4 (short msg.) 4 s
5 = Record voice msg. no. 5 (short msg.) 4 s
Number of long voice messages:
6 = Record voice msg. no. 6 (long msg.)
7 = Record voice msg. no. 7 (long msg.)
8 = Record voice msg. no. 8 (long msg.)
9 = Record voice msg. no. 9 (long msg.)
Voice messages can either be short messages or long messages. The-
re are five short messages (Message no. 1 to message no. 5), limited
to a maximum of four seconds each. Message no. 6 is the first long
message. The number of long messages and their maximum recor-
ding time may be set via configuration step code 50. Upon entering
configuration step code 51 and the respective number of the message
to be recorded, the device will produce a beep and start recording.
After the maximum amount of time for this message has elapsed,
the device will automatically stop recording. You may also stop the
recording process manually by pressing the # key. Doing so will result
in a high-pitched tone to be heard until the maximum recording time
for this message has elapsed because the remainder of the voice
message needs to be erased.
Please note: You may only record the long messages nos. 7; 8 and 9
after you have previously set a corresponding amount of long messa-
ges via configuration step code 50.
52
1 2 3
40 s 20 s 15 s
– 20 s 15 s
– – 10 s
– – –
www.behnke-online.com
Confirmation
#
#
#
#
#
4
10 s #
10 s #
10 s #
10 s #