Telecom Behnke 20-0013 Anleitung Seite 54

Instructions Electronic Add-On Voice / Display / Real Time Clock
GB GB
Configurations and Set-up
Code Parameter
Voice message and telephone function:
55 0 = No voice message
1 = Play voice message no. 1
9 = Play voice message no. 9
This configuration step allows you to determine a voice message to
be played while the telephone function is in use. The message will be
played until you start dialling the telephone number on the keypad.
Voice message and code lock function:
56 0 = No voice message
1 = Play voice message no. 1
9 = Play voice message no. 9
This configuration step allows you to determine a voice message to
be played when the code lock function is in use. The message will be
played until you start entering the code on the keypad.
Voice message and speed dial function:
57 0 = No voice message
1 = Play voice message no. 1
9 = Play voice message no. 9
This configuration step allows you to determine a voice message to
be played when the speed dial function is in use. The message will be
played until you start entering the two digit speed dial number on the
keypad.
Voice message during a direct call function:
58 x [beep] y [beep] z [beep]
x = Voice message before the direct call is dialled
y = Voice message while waiting for the call to be picked up
z = Voice message after the called party has picked up
The following entries are permitted for x; y and z:
0 = No voice message
1 = Play voice message no. 1
9 = Play voice message no. 9
Via this configuration step, you may set up to three voice messages to
be played during a direct call (dialling of a number previously stored
in the device). During this configuration step, the device requires the
entry of three digits from 0 to 9 to specify the voice message to be
played.
54
Default setting: 0
Default setting: 0
Default setting: 0
Default setting: 000
www.behnke-online.com
Confirmation
#
#
#
#
#
#
#
#
#
#