Telecom Behnke 20-0013 Anleitung Seite 51

Code Parameter
Automatically adjust Standard and Daylight Savings time: Default setting: 1
49 0 = disabled
1 = enabled
In case automatic adjusting for Standard and Daylight Savings time is
enabled, the clock time will change from 2:00 am to 3:00 am on the last
Sunday in March and from 3:00 am to 02:00 am on the last Sunday in
October.
Use configuration steps 50 to 59 to set voice messages for the Electronics Add-On. As voice
messages configuration only makes sense with the Electronics Add-On Voice / Display / Real
Time Clock installed, the corresponding configuration steps (with the exception of "Reset Voice
Messages") are only accessible in case an Electronics Add-On Voice / Display / Real Time Clock
is actually installed. You need a 12 V additional power supply unit to run the Electronics Add-On
Voice / Display / Real Time Clock.
Reset Voice Messages:
50 ****
Performing a reset will return the configuration step codes 51 to 59
to their default settings. In case both the Electronics Add-On Voice /
Display / Real Time Clock and an additional 12 V power supply are con-
nected, performing a reset will erase all recorded voice messages and
the number of long messages will be set to its default setting 1.
Specify the number of long voice messages:
50 * * * Number of long voice messages
1 = 1 message (message no. 6: 40 s)
2 = 2 messages (message no. 6: 20 s and message no. 7: 20 s)
3 = 3 messages (message no. 6: 15 s; message no. 7: 15 s and
message no. 8: 10 s)
4 = 4 messages (message no. 6: 10 s; message no. 7: 10 s;
message no. 8: 10 s and message no. 9: 10 s)
The Electronics Add-On Voice / Display / Real Time Clock will store
up to five short voice-messages, each a maximum of 4 seconds long.
Additionally, the Add-On will store longer voice messages of up to 40
seconds. Use this configuration step to divide these 40 seconds into
a maximum of up to 4 long messages. The maximum amount of voices
messages results from the five short messages and the set number of
long messages, i.e. according to your configuration you will either have
six (five short + one long) up to a maximum of nine (five short + four
long) voice messages available.
Please note: When changing the number of long messages, all previous-
ly recorded messages will be erased; the short messages will not be
erased.
www.behnke-online.com
Instructions Electronic Add-On Voice / Display / Real Time Clock
Configurations and Set-up
Confirmation
#
#
#
Default setting: 1
#
GB
51