AsViva RA6 O Benutzerhandbuch Seite 44

ASSEMBLY INSTRUCTION
Step 4
NOTE: The right pedal (41) has "R" stamped on the end of the pedal shaft. The right pedal (41) has to
be turned in clockwise. The left pedal (39) has "L" stamped on the end of the pedal shaft and has to be
turned in counterclockwise.
Step 1: Thread the right pedal (41) onto the right crank (37) located on the inside of the crank cover
(35) as shown. Tighten the pedal securely. Select the right pedal strap (42) which has "R" marked on
the bottom side of the strap. Snap the three hole end onto the inside edge of the right pedal (41). Snap
the other end onto the outside edge of the right pedal (41) with the "R" mark on the bottom of the right
pedal strap (42). Select adjustment holes which allow your foot to be easily removed from the pedals.
Do the same way to attach the left pedal (39) onto the left crank (36) and snap the left pedal strap (40)
onto the left pedal (39).
Step 2: Refer to the insert drawing. Plug the pulse sensor wire (73) into the socket of the pulse coil
wire (74) located on the seat carriage (64). Plug the pulse coil wire (74) into the socket of the pulse
connecton wire (75) located on the bracket on the main frame (1).
44