AsViva RA6 O Benutzerhandbuch Seite 50

COMPUTERFUNCTION
C. SET THE TIME
D. SET THE DISTANCE
D. SET THE DISTANCE
E. SET THE CALORIES
F. SET THE PULSE
F. SET THE PULSE
G. START EXERCISE
G. START EXERCISE
50
Rotate MODE to set the desired TIME (1:00 TO 99:00) and press MODE to confirm.
NOTE for TIME:
Count Up: If a target time was not selected, TIME will count up from 0:00 to
maximum 99:59 minutes.
Count Down: If you have set the target time (1:00 TO 99:00; 1 MINUTE
INCREMENT), the console will count down from that selected target time down to
0:00.
Rotate MODE to set the desired DISTANCE (1.0 TO 99.0 KM/MILE) and press MODE to
confirm.
NOTE for DISTANCE:
Count Up: If a target distance was not selected, this would measure the total distance
from 0.00 to 99.9 km/mile.
Count Down: If you have set the target distance (1.0 TO 99.0; 1 KM/MILE
INCREMENT), the console will count down from that selected target distance down
to 0.
Rotate MODE to set the desired CALORIE (10 TO 990 CAL) and press MODE to confirm.
NOTE for CALORIES:
Count Up: If a target calorie was not selected, this would measure the total calories
from 0 to 9999 cal.
Count Down: If you have set the target calorie (10 TO 990; 10 CAL INCREMENT),
the console will count down from that selected target calorie down to 0.
Rotate MODE to set the desired PULSE (30 TO 230 BPM) and press MODE to confirm.
NOTE for PULSE:
Warning Reminder: If you have set the target pulse (30 TO 230 BPM (Beats Per
Minute; 1 BPM INCREMENT) and console buzzer will beep when actual heart rate
is over the target value during workout.
a. Press START/STOP to begin your exercise.
b. During workout, you can rotate MODE to select the torque/tension level (from 1 to 32
levels).
c. During workout, press MODE to see each current workout value (SPEED, RPM, TIME,
DISTANCE, CALORIES, WATT, PULSE).
NOTE for HEART RATE:
You must place both of your hands on the Pulse Sensors located on the Handlebar.
Your pulse will be displayed approximately few seconds after the heart symbol "
displayed.
If you do not place your hands correctly and a few seconds pass without a pulse
input, the console will turn off the pulse circuit and then display an error message "P".
Place your hands back on the Pulse Sensors correctly, the pulse readout will appear
again.
" is