AsViva RA6 O Benutzerhandbuch Seite 45

ASSEMBLY INSTRUCTION
Step 5
Step 1: Insert the sensor wire (29) and pulse connection wire (75) into the bottom end of the meter
post (31) and pull them out of the top of the meter post (31). Pull the handlebar (25) and twist the strap
(21) and slide the strap through the gap into the hole in the bottom of the meter post (31). Slide the
meter post (31) onto the main frame (1) and secure it with screw (84).
Step 2: Plug the middle connection wire (29) to the meter connection wire (30a).
Plug pulse connection wire (75) to the meter connection wire (30b).
Push the excess wires back into the meter post (31). Attach the meter (30) onto the meter
post (31) with two bolt, button head M5x0.8x12mm (115).
NOTE: Please be careful not to damage all connection wires when attaching the meter (30)
Step 3: Refer to the Figure 1 image above. Tuurn counterclockwise the adjustment pad until it stands
on the ground completely to ensure the stability while using it.
Lubricate the silicone to the rollers sliding path on the aluminum r
NOTE: Please be careful to not damage the sensor wire when attaching the meter (30).
Step 4:
a. A bottle of silicone is packed together with user's manual.
b. Gently apply the silicone to the rollers sliding path
(inner upper side and inner bottom side) on the aluminum rail.
Note: Apply liberally but be cautious not to spill the lubricant as
applied surfaces will become very slippery. To clean spills use
warm soapy water, repeat if necessary.
c. Then slowly slide the Seat forward and backward for a few seconds
allowing the lubricant spread evenly on the rollers sliding path on aluminum rail.
45