Adjusting The Level Of The Effect Speakers - Yamaha DSP-AZ2 Bedienungsanleitung

ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS

You can adjust the output level of each effect speaker
(center, left and right rear, rear center, front effect and
subwoofer) while listening to a music source.
Adjustment should be made with the remote control.
A/B/C/D/E
TV INPUT
TV VOL
TV MUTE
2
ON SCREEN
LEVEL
SLEEP TEST
3
1
Set PARAMETER/SET
MENU to PARAMETER.
2
Press LEVEL repeatedly to select the
speaker(s) you want to adjust.
Each time you press LEVEL, the selected speaker
changes and appears on the front panel display and
on the video monitor as follows: center, right rear,
rear center, left rear, front effect and subwoofer.
LEVEL
y
• Once you press LEVEL, you can also select the speaker(s) to
be adjusted by pressing n/k.
PRESET
MUTE
CH VOLUME
STEREO
DISC EFFECT
1
PARAMETER
SET MENU
PARAMETER
SET MENU
Center speaker output level
Right rear speaker output
level
Rear center speaker output
level
Left rear speaker output
level
Front effect speaker output
level
Subwoofer output level
3
Press –/+ to adjust the speaker output level.
• The control range for the center, left and right rear,
front effect or rear center speakers is from +10 dB
to –10 dB.
• The control range for the subwoofer is from 0 dB
to –20 dB.
Notes
• When you adjust the output level with LEVEL, the settings you
made with the test tone ("TEST DOLBY SUR." or "TEST
DSP") will be changed.
• When PARAMETER/SET MENU is set to SET MENU, you
cannot adjust the output level by using LEVEL. However, each
time you press LEVEL, the current level of each speaker
appears on the front panel display and you can check the
speaker level.
• When the speaker output modes for "1A CENTER SP", "1C
REAR L/R SP", "1D REAR CT SP" and "1F FRONT EFCT
SP" are set to NONE, and "1E LFE/BASS OUT" to MAIN, the
output level of those speakers cannot be adjusted because there
is no sound coming from these speakers.
• During playback of the source input through the 6CH INPUT
jacks, the level can be adjusted independently for the center,
right and left rear, and subwoofer.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby
mode. However if the power cord is disconnected from
the AC outlet, or the power supply is cut for more than
one week, the stored data will be lost. If so, set the
output level again.
67