Adjusting The Speaker Balance - Yamaha DSP-E800 Bedienungsanleitung

This procedure lets you adjust the sound output level
balance between the main, center and rear speakers by using
the built-in test tone generator. When this adjustment is
performed, the sound output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound field
processor, the Dolby Pro Logic decoder, Dolby Digital
decoder and DTS decoder.
The adjustment of each speaker sound output level should
be performed at your listening position with the remote
control. After completing the adjustments, use VOLUME
+/– at your listening position to check if the adjustments are
satisfactory.
2
NATURAL SOUND AV PROCESSOR/AMPLIFIER DSP–E800
STANDBY/ON
– SET MENU + NEXT TAPE/MD MON
/6CH INPUT
POWER
2
PROGRAM
/DTS MOVIE MOVIE
SUR. THTR 1 THTR 2
1 2 3
MONO MOVIE TV SPORTS DISCO
4 5 6
ROCK HALL
7 8
3,7
TEST EFFECT
DSP
TIME/LEVEL SET MENU
5
6CH INPUT
CD TUNER TAPE/MD
E-14

ADJUSTING THE SPEAKER BALANCE

D I G I T A L
CINEMA DSP DOLBY
D I G I T A L
S U R R O U N D
INPUT SELECTOR
28
40
INPUT MODE
60
EFFECT PROGRAM
CD TUNER TAPE/MD
DVD/LD D–TV VCR
CBL/SAT
SLEEP MUTING
– +
VOLUME
4
6
1
Set VOLUME to the "m"
position.
2
Turn the power on.
3
Press TEST.
"TEST LEFT" appears on the display.
TEST
1
4
Turn up the volume.
VOLUME
16
20 12
You will hear a test tone (like pink noise) from each
8
4
speaker for about two seconds in the following order:
2
00 0
–dB
left main speaker, center speaker, right main speaker,
right rear speaker and left rear speaker. The display
changes as shown below.
–
VOLUME
Notes
• If the test tone cannot be heard, turn down the volume, set the unit
in the standby mode and check the speaker connections.
• If the test tone cannot be heard from the center speaker, check the
setting of "CENTER SP" on the SET MENU.
VOLUME
28
40
60
Front panel
POWER
or
STANDBY/ON
Front panel Remote control
TEST
LEFT
TEST CENTER
+
TEST L SUR. TEST R SUR.
16
20 12
8
4
2
00 0
–dB
TEST
RIGHT