Test Dsp - Yamaha DSP-AZ2 Bedienungsanleitung

TEST DSP

Select "TEST DSP" to match the output levels of the
front effect speakers to the main speakers.
Note
• You cannot enter the "TEST DSP" mode if "1F FRONT EFCT
SP" is set to NONE.
A/B/C/D/E
TV INPUT
TV VOL
TV MUTE
ON SCREEN LEVEL
SLEEP TEST
1, 4
1
Press TEST repeatedly to
output the test tone.
2
Adjust the volume so you
can hear the test tone.
FRONT
LEFT
The test tone is heard alternately from the front effect
speakers and main speakers. The tone is produced for
2.5 seconds each time. Press k to hear the test tone
from the front effect L speaker, and n to hear the test
tone from the front effect R speaker.
PRESET
2
MUTE
CH VOLUME
STEREO
DISC EFFECT
PARAMETER
SET MENU
3
TEST
VOLUME
FRONT
RIGHT
ADJUSTING THE SPEAKER OUTPUT LEVELS
The state of the test tone output is also shown on the
monitor by an image of the audio listening room.
This is convenient for adjusting each speaker level.
TEST DSP
Front panel display also indicates from which
speaker the test tone is output as follows:
TEST MAIN ¡ TEST FRONT ¡ TEST MAIN ¡ ...
Note
• If the test tone cannot be heard, turn down the volume, set this
unit in the standby mode and check the speaker connections.
3
Press –/+ repeatedly to
adjust the output level of
the front effect speakers
so that the output level
coming from each
speaker is the same.
While adjusting, the test tone is heard from the front
effect speaker.
Note
• Main L/R speaker level cannot be adjusted by itself. Use
VOLUME to adjust the main volume.
4
When the adjustment is
complete, press TEST to
stop the test tone.
y
• It is not necessary to readjust the speaker level once it is set as
long as you do not change the speakers. You can enjoy listening
to or watching the input source with the desired volume by
adjusting the volume key.
• You can increase the output levels of the front effect speakers
to +10 dB. If the output level of these speakers is lower than
that of the main speakers even after you have increased the
output level of these speakers up to +10 dB, set "1G MAIN
LEVEL" on the SET MENU to –10 dB (see page 59). This
setting decreases the main speaker output level to about one-
third of the normal level. After you have set "1G MAIN
LEVEL" on the SET MENU to –10 dB, adjust the levels for
the center and rear speakers again.
CONNECTIONS
M A I N
TEST
27