Digital Sound Field Processor (Dsp) Effect; Selecting A Dsp Program; Canceling The Sound Effect (Turning Off The Effect Speakers) - Yamaha DSP-E800 Bedienungsanleitung

DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT

Selecting a DSP Program

You can enhance your listening experience by selecting a
DSP program. Refer to pages 22 to 24 for details about each
program.
NATURAL SOUND AV PROCESSOR/AMPLIFIER DSP–E800
STANDBY/ON
– +
SET MENU NEXT TAPE/MD MON
/6CH INPUT
2
1
MONO MOVIE
4
7
TIME/LEVEL
6CH INPUT
1
Make sure that the effect speakers (center and
rear) and subwoofer are turned on.
2
Press PROGRAM l or h repeatedly (or one of
the PROGRAM selector buttons) to select the
desired program.
The name of the selected program appears on the
display.
PROGRAM
Front panel
PRO LOGIC
MOVIE THEATER
DSP
DSP program name
y
If desired, adjust the delay time and the sound output level of each
speaker. (Refer to pages 29 and 30 for details.)
E-20
D I G I T A L
CINEMA DSP DOLBY
D I G I T A L
S U R R O U N D
INPUT SELECTOR
20
28
40
INPUT MODE
60
EFFECT PROGRAM
2
POWER
PROGRAM
/DTS MOVIE MOVIE
SUR. THTR 1 THTR 2
2 3
TV SPORTS DISCO
5 6
ROCK HALL
8
TEST EFFECT
DSP
SET MENU
CD TUNER TAPE/MD
PROGRAM
/DTS MOVIE MOVIE
SUR. THTR 1 THTR 2
1 2 3
MONO MOVIE TV SPORTS DISCO
or
4 5 6
ROCK HALL
7 8
Remote control
DVD/LD TUNER
D–TV CD
VCR CBL/SAT
2
Notes
• You can select a DSP program for each of the input sources. Once
you select a program, it is linked with the input source selected at
that time. So, when you select the input source next time, the
same program is automatically selected.
• When a monaural source is being played with PRO LOGIC/
Normal or PRO LOGIC/ENHANCED, no sound will be heard
from the main speakers and the rear speakers. Sound can only be
heard from the center speaker. However, if "CENTER SP" on the
VOLUME
16
12
8 SET MENU is set to the NONE position, the center channel
4
sound is output from the main speakers.
2
00 0
–dB
• When a source connected to the 6CH INPUT terminals of this
unit is selected, the digital sound field processor cannot be used.
• When high-rate 96-kHz sampling 24-bit digital signals are input
to this unit, no DSP program can be selected and the sound is only
output from right and left main speakers as a normal 2-channel
stereo sound.
Canceling the Sound Effect (turning
off the effect speakers)
Press EFFECT to cancel the sound effect and
monitor only the main sound.
Press EFFECT again to turn the sound effect back on.
Front panel
Notes
• If you turn off the sound effect when Dolby Digital or DTS is
decoding, the sounds of the center and rear channels are mixed
and output from the main speakers.
• If you turn off the sound effect when Dolby Digital or DTS is
decoding, it may happen that the sound is output faintly or not
output normally, depending on the source. In this case, turn sound
effect back on.
EFFECT
EFFECT
or
Remote control