Impedance Selector Switch - Yamaha DSP-AX1 Bedienungsanleitung

Right Rear Left Rear
Speaker
SPEAKERS
FRONT
+ +
– –
REAR
+ +
– –
+ +
– –
CENTER REAR CENTER
WARNING
Do not change the IMPEDANCE
SELECTOR switch setting while the power
to this unit is on, otherwise this unit may be
damaged.
IF THIS UNIT FAILS TO TURN ON
WHEN THE STANDBY/ON SWITCH IS
PRESSED:
The IMPEDANCE SELECTOR switch
may not be set to either end. If so, set the
switch to either end when this unit is in the
standby mode.
(General Model)
IMPEDANCE SELECTOR
SET BEFORE POWER ON
FRONT
REAR
REAR CENTER
CENTER
MAIN A OR B
A + B
FRONT
REAR
REAR CENTER
CENTER
MAIN A OR B
A + B
22
Speaker
Subwoofer
system
Hookups
Connecting a Rear Subwoofer
By using both Front and Rear Subwoofers, the CINEMA-DSP sound field
programs can produce realistic movie effects with powerful, dynamic sound. To
take advantage of this dynamic sound, be sure to set the 1C. REAR L/R SP item
in the SET MENU to "LARGE" (see page 37), and connect your Rear speakers
and Subwoofer as shown below.
Connect the right + input terminal on your Subwoofer to the REAR
1
1
R + terminal, and the right – input terminal on your Subwoofer to
the REAR R – terminal with speaker cords.
Connect the left + input terminal on your Subwoofer to the REAR
2 2
L + terminal, and the left – input terminal on your Subwoofer to the
REAR L – terminal with speaker cords.
Connect your Rear speakers to the output terminals on the Rear
3
3
Subwoofer.
Be sure to connect the Rear speakers to the Subwoofer with the correct
polarity.
Note:
• Adjust the speaker volume for the Subwoofer with the controls on the Subwoofers,
not on the DSP-AX1.

Impedance Selector switch

Select the position whose requirements your speaker system meets.
(Upper position)
Front Effect:
The impedance of each speaker must be 6Ω or higher.
Rear: The impedance of each speaker must be 4Ω or higher.
Rear Center:
The impedance of the speaker must be 4Ω or higher.
Center: The impedance of the speaker must be 4Ω or higher.
Main: If you use one pair of main speakers, the impedance of each
speaker must be 4Ω or higher.
If you use two pairs of main speakers, the impedance of each
speaker must be 8Ω or higher.
(Lower position)
Front Effect:
The impedance of each speaker must be 8Ω or higher.
Rear: The impedance of each speaker must be 8Ω or higher.
Rear Center:
The impedance of the speaker must be 8Ω or higher.
Center: The impedance of the speaker must be 8Ω or higher.
Main: If you use one pair of main speakers, the impedance of each
speaker must be 8Ω or higher.
If you use two pairs of main speakers, the impedance of each
speaker must be 16Ω or higher.