Connecting Audio Components; Connecting An Am/Fm Tuner; Connecting A Turntable; Connecting A Cd Player - Yamaha DSP-AX1 Bedienungsanleitung

Connecting Audio Components

Before you connect any components, disconnect the power supply to all the components you plan to connect including the DSP-AX1 and
determine which jacks are for the left and right channels and for input and output.
When you connect other YAMAHA audio equipment (such as a CD player or changer, Tuner, MD deck, or tape deck), connect to terminals
with the same number labels. Yamaha applies this labelling system to all its products.
In the hookup illustrations on the following pages:
indicates signal direction,
indicates coaxial cables,
C
indicates left side analog cables,
L
indicates right side analog cables,
R
indicates optical cables; and,
O
indicates S-video cables.
S
After you finish all hookups, check them again to make sure they are correct.
AM/FM Tuner
RF(AC-3) AUDIO AUDIO
GND
PHONO
LD
CD
CD
TUNER
DVD
CBL IN
(PLAY)
/SAT
COAXIAL TAPE
OPTICAL
OUT
CD
(REC)
Output
Turntable
Ground
RF(AC-3) AUDIO
GND
PHONO
LD
CD
CD
TUNER
DVD
CBL IN
(PLAY)
/SAT
Optical Output
CD Player
Coaxial Output
C
RF(AC-3)
GND
LD
O
CD CD
TUNER
DVD
CBL IN
(PLAY)
/SAT
COAXIAL TAPE
OPTICAL
OUT
CD
(REC)
IN IN
(PLAY)
(PLAY)
MD
MD
OUT
OUT
(REC)
(REC)
MAIN
DVD
16
Audio Output
L
R
VIDEO COMPONENT VIDEO
Y P /C P /
VIDEO S VIDEO B B R
DVD A
LD
B
D-TV
C
CBL
/SAT
M
IN
PREOUT/MAIN
L
R
AUDIO VIDEO
VIDEO S VIDEO
DVD
LD
D-TV
CBL
/SAT
Analog
Output
L
R
AUDIO AUDIO VIDEO COMPONEN
PHONO VIDEO S VIDEO Y P
DVD A
LD
B
D-TV
C
CBL
/SAT
IN
VCR 1
OUT
IN
IN
REMOTE 1
VCR 2
OUT
OUT
Hookups

Connecting an AM/FM Tuner

Connect the left and right signal output jacks on your tuner
1
1
to the TUNER 2 L and R jacks.

Connecting a Turntable

Connect the left and right signal output cords to the PHONO L and
1
1
R jacks.
Note:
• These jacks are for connecting a turntable with an MM or high output MC
cartridge. If you have a turntable with a low output MC cartridge, use an inline
boosting transformer or MC-head amplifier when connecting to these jacks.
Caution:
• The GND terminal does not electrically ground the turntable. It simply reduces
noise in the signal. In some cases, you may hear less noise if you do not connect to
the GND terminal.

Connecting a CD Player

Connect the left and right analog signal output jacks on your CD
1 1
player to the CD 1 L and R jacks.
Notes:
• The COAXIAL CD and OPTICAL CD jacks are available for a CD player which
has coaxial or optical digital outputs.
• When you connect a CD player to both the COAXIAL CD and OPTICAL CD
jacks, priority is given to the input signals from the COAXIAL CD jack.
• The OPTICAL jacks on this unit conform to the EIA standard. If you use a fiber
optic cable that does not conform to this standard, the DSP-AX1 may not function
properly.