Hookups; Connecting To Digital Jacks; About The Video Jacks; About The Rf (Ac-3) Signal Input Jack - Yamaha DSP-AX1 Bedienungsanleitung

Connecting to Digital Jacks

The DSP-AX1 has digital jacks for direct transmission of digital signals through either coaxial or fiber optic cables. You can use the digital
jacks to input PCM, DTS and Dolby Digital bitstreams. When you connect components to both the COAXIAL and OPTICAL jacks (for CD,
DVD, and CBL/SAT) priority is given to the input signals from the COAXIAL jack. All digital input jacks are acceptable for 96 kHz/24 bit
digital signals.

About the Video Jacks

There are three types of video jacks. Video signals input through the VIDEO jacks are the conventional composite video signals. Video
signals input through the S VIDEO jacks are separated into luminance (Y) and color (C) video signals. The S-video signals achieve high
quality color reproduction.
Video signals input through the COMPONENT VIDEO jacks are separated into luminance (Y) and color difference (P
signals. The jacks are also separated into three for each signal. The description of the component video jacks may be different depending on
the component (e.g. Y, C , C / Y, P
B R
Composite VIDEO terminal
S VIDEO terminal
COMPONENT VIDEO terminals
Y P /C
B B
About the RF (AC-3) Signal Input Jack
If your LD player has an RF (AC-3) signal output jack, connect it to the
signals are input at the same time, priority is given to the RF signals. When you want to reproduce
to "D.D. RF" using INPUT MODE.
RF(AC-3)
About the Dust Protection Cap
Pull out the cap from the optical jack before you connect the fiber optic cable.
Do not discard the cap. When you are not using the optical jack, be sure to put the
cap back in place. This cap protects the jack from dust.
, P / Y, B-Y, R-Y/ etc.). Component video signals provide the best quality in picture reproduction.
B R
Note:
• Each type of video jack works independently. Signals input through the composite
Caution:
• Use a commercially available S-video cable when connecting to the S VIDEO jacks,
• When you are using the COMPONENT VIDEO jacks, check the details in the owner's
P /C
R R
Note:
•
LD
Caution:
• Even if you connect an LD player with an

Hookups

video, S-video, and component jacks are output through the corresponding composite
video, S-video, and component jacks respectively.
and commercially available video cables when connecting to the COMPONENT
VIDEO jacks.
manual that came with the component being connected.
RF (AC-3) input jack on this unit. If
RF (AC-3) signals cannot be output using the REC OUT selector. When you record
sound or images from an LD player, be sure to connect the player to either the
DIGITAL OPTICAL or analog AUDIO jacks.
cannot reproduce Dolby Digital sound from all LD discs. You must playback an LD
disc encoded with Dolby Digital signals in order to take advantage of the Dolby Digital
sound.
/C , P /C ) video
B B R R
RF (AC-3) and analog
RF (AC-3) signals, set the input mode
RF (AC-3) output jack to this unit, you
15