Modes: STEREO/PARALLEL/BRIDGE
STEREO mode
In this mode, channels A and B operate independently
(as a conventional stereo amp).
The CHANNEL A input signal will be output from the
CHANNEL A output jacks, and the CHANNEL B input
signal will be output from the CHANNEL B output
jacks.
PARALLEL mode
In this mode, the CHANNEL A input signal will be
output from the output jacks of both channels A and B.
The CHANNEL B input jack is not used. The (channel)
A and B volumes can be adjusted independently.
SPEAKER IMPEDANCE
In STEREO and PARALLEL modes, the minimum load
(=speaker) impedance is 4Ω. In BRIDGE mode it is 8Ω.
Make sure that the impedance does not fall below this
specified impedance.
STEREO mode connections
BRIDGE
Set to STEREO
STEREO
PARALLEL
PARALLEL mode connections
BRIDGE
Set to PARALLEL
STEREO
PARALLEL
4
SPEAKERS
CHANNEL B
CHANNEL A
STEREO
BRIDGE
MAX. OUTPUT 450W/4Ω (STEREO)
MAX. OUTPUT 900W/8Ω (BRIDGE)
–
+
+
–
4Ω min.
4Ω min.
Speaker System
SPEAKERS
CHANNEL B
CHANNEL A
STEREO
BRIDGE
MAX. OUTPUT 450W/4Ω (STEREO)
MAX. OUTPUT 900W/8Ω (BRIDGE)
–
+
+
–
4Ω min.
4Ω min.
Speaker System
BRIDGE mode
In this mode, the CHANNEL A input signal will be
output from the BRIDGE output jacks. In this case, use
the front panel (channel) A volume control to adjust the
volume.
BRIDGE mode connections
BRIDGE
Set to BRIDGE
STEREO
PARALLEL
SPEAKERS
CHANNEL B
CHANNEL A
STEREO
BRIDGE
MAX. OUTPUT 450W/4Ω (STEREO)
MAX. OUTPUT 900W/8Ω (BRIDGE)
–
+
8Ω min.
Speaker System