Connecting External Amplifiers - Yamaha DSP-AX1 Bedienungsanleitung

Connecting External Amplifiers

If you want to increase the power output to the speakers, or want to use another amplifier, connect an external amplifier to the PRE OUT/
MAIN IN terminals as follows.
~ MAIN jacks
MAIN OUT jacks ..... Main channel line output jacks.
The signals output through these jacks
are affected by BASS, TREBLE,
BALANCE, and BASS EXTENSION
settings.
MAIN IN jacks .......... Line input to the DSP-AX1 Main
channel amplifiers.
Ÿ CENTER jacks
CENTER OUT jack . Center channel line output jacks.
CENTER IN jack ..... Line input to the DSP-AX1 Center
channel amplifier.
! REAR CT jack
Rear Center channel line output jack.
Note:
• When RCA pin plugs are connected to the PRE OUT/MAIN IN output jacks for output to external amplifiers, the corresponding internal amplifiers
will be muted.
Hookups
PREOUT/MAIN IN
FRONT
REAR
(SURROUND)
SUB
WOOFER
SPLIT
MONO
CENTER
IN
REAR CTR
CENTER
OUT
MAIN
IN
MAIN
OUT
⁄ SUBWOOFER jacks
Subwoofers reinforce very low frequencies.
MONO ...................... Main, Center and Rear channel
SPLIT ....................... The SPLIT jacks output stereo
Adjust the volume level of the subwoofer with the control on
the subwoofer. Subwoofer volume cannot be adjusted from
this unit. Depending on the settings in SET MENU items
1. SPEAKER SET, 3A. LFE LEVEL and 4A. LFE LEVEL,
some signals may not be output from the SUBWOOFER
jacks.
@ FRONT
Front Effect channel line output jacks.
¤ REAR (SURROUND)
Rear channel line output jacks.
frequencies below 90 Hz are output
through this jack. You can also direct
DTS and Dolby Digital LFE signals to
this output.
separation for the Main and Rear
channels and a split mono signal for the
Center and LFE channels.
23