Installation & Commissioning; Hydraulic Installation - ECOLAB DOS ECO Kurz- Betriebsanleitung

2.13 Installation & commissioning
CAUTION!
Installation and commissioning work must only be carried out by
authorized, trained service technicians. We urgently recommend the
service of the company Ecolab Engineering GmbH.
Always pull the mains power plug and secure against accidental startup
before working on electrical components.
To prevent overfilling etc we recommend using leakage systems.
Make sure components not pre-installed are mounted correctly to prevent
malfunctions or diminished functionality and eliminate any risks for the
system or persons.
Before starting the system for the first time, check all system components
for proper and tight fit.
We urgently recommend installing flush line connections to ensure the
system can be easily, safely, and quickly cleaned when commissioning, re-
commissioning after downtime due to maintenance or repairs.
The empty signal must deactivate the pump below a certain level (in the
container).
We strongly recommend using a suction lance with an empty detection
system and floor suction valve with dirt filter from our range of accessories!
Requirements for system components provided by the operator
WARNING!
To prevent damage to the system, make sure the system components
made available by you (pipe connections/flanges) are mounted properly.
When transitioning from plastic to stainless steel pipes, we recommend
using compensators to minimize stresses during installation and operation.
If installation is not carried out by the service department of the company
Ecolab Engineering GmbH, please make sure the pipes and metering lines
are the correct materials and have the required diameter and length to
ensure trouble-free operation of the system.
2.13.1

Hydraulic installation

CAUTION!
All of the hydraulic work must be carried out by authorized and trained
service technicians and in accordance with local rules and regulations.
When installing the metering line, make sure stresses due to stretches are
avoided. Metering lines should only be as long as necessary and must be
checked regularly for leaks or damage.
All screw connections must be checked and tightened if necessary (these
may become loose due to large fluctuations of the ambient temperature or
vibrations). Only hand-tighten plastic screw connections to avoid damage to
the components!
To detect and eliminate leaks quicker, we recommend employing a leak
detection system, e.g. by using a flow monitor.
To protect system components, it is strongly recommended to use a suction
lance with an empty indicator and a dirt particle filter from our range of
accessories!
The empty indicator must switch off the pump when a certain level is
reached (in the tank).
27
Safety
417101656 Rev. 01-10.2019