ECOLAB DOS ECO Kurz- Betriebsanleitung Seite 108

5.2.3.4.1 Operating mode [Pulse] - setting
In this operating mode, pulse control is performed using a water meter.
1. Open the main menu.
2. [Operating mode] - [Pulse] .
3.
[Next button]
ð Screen change for setting: 'Pulse interval' .
4. 'Set the litres' with decimal places using the scrollbar.
5. Select the field for entering the value after the decimal point.
ð The colour changes to dark blue, which indicates that the field is ready for input.
6. Set the decimal point with the scrollbar.
7.
Press the Next
ð The screen changes to the 'Pulse memory' prompt.
8. Select whether the 'pulse memory' is to be used.
ð If you select the 'Pulse memory' , a
9. Press the
ð Settings are saved, and the screen returns to the [Operating mode] .
10. Go to [Main menu] by pressing the button
[Operating mode] [Timer]- setting
In this operating mode you can select the following settings:
"Weekly programme" :
With the 'Seven-day programme' , metering starts at selected metering
times. You can select seven metering times per weekday, and the metering
duration and metering capacity for each metering operation separately.
"Interval programme" :
With the 'Interval programme' , the pump runs and pauses for the set pulse
duty factor and interruption durations. The pump repeats the process
continually and you can select the pulse duty factor, interruption duration
and metering capacity.
5.2.3.4.2 Operating mode [Current] - setting
Proceed as follows:
1. Open the main menu.
2. [Operating mode] - [current] .
3.
Press the Next
ð Screen change for the [current] setting:
4. 'Select current range' :
n [0 to 20 mA]
n [4 to 20 mA]
n [20 to 4 mA]
n [20 to 0 mA]
n [variable]
.
button.
button.
button.
47
Comissioning and operation
appears in the selection box.
.
417101656 Rev. 01-10.2019