Positioning The Lateral X-Ray Cassette Holder - Prime X Option - Stryker Prime Serie Bedienungsanleitung

English
Positioning the upright X-ray cassette holder - Prime X option (Continued)
EN
5. Insert an X-ray cassette from either side of the cassette holder or pull the slider release arrow (B) to release the
cassette holder from the Fowler, position the cassette, and secure the cassette holder in the Fowler backrest
weldment.
6. To adjust the height of the cassette, loosen the knob (E) and move the cassette support rail (D) up or down until
you reach the desired height.
7. Tighten the knob (E) to secure the cassette support rail in place.
8. When the X-ray process is complete, pull up on the slider release arrow (B) to release the cassette holder from the
Fowler backrest weldment.
9. Remove the X-ray cassette from the cassette holder.
10. Close and stow the cassette holder.

Positioning the lateral X-ray cassette holder - Prime X option

WARNING
• Always take protective measures when you use the upright or lateral X-ray cassette holder. The X-ray cassette
holder does not protect against radiation.
• Always refer to local, state, and federal guidelines in addition to facility protocols for safety before you use Prime X
option with radiation generating devices. Radiation generating devices may produce residual, stray, or scattered
radiation.
• Always use caution when you take X-rays with the Fowler backrest in the upright position or when you use a lateral
cassette.
• Always use extra caution when you use a mattress thicker than 2.5 in. or a mattress overlay with Prime X option.
1-50
Accessories
C
B
A
E
Figure 1-24: X-ray cassette holder
1125-309-005 REV A
C
D
www.stryker.com