Specifications - Sony YS-DX516P Bedienungsanleitung

Specifications

Specifications
General
Signal format Based on PAL color signal
standard (YS-DX516P)
Based on CCIR B/W signal
standard (YS-DX416CE)
Camera
Camera signal input synchronization
Asynchronous
Camera input connectors (IN)
VS/VBS, 1.0 Vp-p/75 Ω, BNC
connector × 16
Camera output connectors (OUT)
Throughput of each input,
1.0 Vp-p/75 Ω, BNC connector
× 16
Video
VCR input connector (VCR IN)
• Composite input
VS/VBS, 1.0 Vp-p/75 Ω, BNC
connector × 1
• S-VHS input connector (S-VIDEO VCR IN)
Separate YC signals, DIN
connector (S terminal) × 1
(YS-DX516P only)
Y signal: 1.0 Vp-p/75 Ω,
unbalanced, synchronous;
C signal: 0.286 Vp-p/75 Ω,
unbalanced
VCR output connector (VCR OUT)
• Composite output
VS/VBS, 1.0 Vp-p/75 Ω, BNC
connector × 1
• S-VHS output terminal (S-VIDEO VCR OUT)
Separate YC signals, DIN
connector (S terminal) × 1
(YS-DX516P only)
Y signal: 1.0 Vp-p/75 Ω,
unbalanced, synchronous;
C signal: 0.286 Vp-p/75 Ω,
unbalanced
68
(GB)
Monitor
Monitor 1 output connector (MONITOR OUT 1)
VS/VBS, 1.0 Vp-p/75 Ω, BNC
connector × 1
Separate YC signals, DIN
connector (S terminal) × 1
(YS-DX516P only)
Y signal: 1.0 Vp-p/75 Ω,
unbalanced, synchronous;
C signal: 0.286 Vp-p/75 Ω,
unbalanced
Camera live picture or VCR
playback picture signal output:
full screen, sequential display,
Multi-display screen
Monitor 2 output connector (MONITOR OUT 2)
VS/VBS, 1.0 Vp-p/75 Ω, BNC
connector × 1
Camera live picture signal output:
full screen (can be set in
(MONITOR SET) menu to
display the same image as
monitor 1)
Terminal
Control terminal (CONTROL)
• Alarm input
No voltage, make-contact switch
input × 16 (Low input)
• Sensor alarm output
Alarm output × 16 (low output,
normally open (NO))
• Remote input (R1, R2)
2-wire type with resistance-based
identification system
• Alarm output (A)
DC 5 V, 5.7 kΩ (Low output)
• Switching input (S)
Low input, for input signal from
SW OUT of timelapse VCR/real
time recorder (as per this
manufacturer specifications)
• RS-485 control terminal
RJ-11 type: 2 terminals (A/B)
Push-lock type: 3 terminals (A, B,
GND)
• RS-232C terminal: 9-pin D-SUB