Sony YS-DX516P Bedienungsanleitung Seite 40

Menu Setting Mode
(VCR SET) menu
If the VCR is not Equipped with an SW
(switching) Output Connector
VCR MODE
TLS: If using a timelapse VCR. (Default setting)
REAL: If using a real time VCR.
REC SPEED
The recording speed settings on this unit correspond to
recording durations on an E-180 tape.
With a timelapse VCR
Set the recording speed to match the recording speed
of the timelapse VCR.
The available speeds are: 3 (3H) (Default setting), 12
(12H), 24 (24H), 48 (48H), 72 (72H), 96 (96H), 120,
168, 240, 360, 480, 720, 960 (960H)
With a real time VCR
Set the recording speed to match the recording speed
of the real time VCR.
The available speeds are: 6 (6H) (Default setting), 18
(18H), 30 (30H), 48 (48H), 72 (72H), 96 (96H), 120,
168, 240, 360, 480, 720, 960 (960H)
Note
Real time VCRs speed is based on an E-240 cassette
tape. When setting this unit to 6H, 18H or 30H, refer
to the table 1 for the speed correspondence, and select
the speed on the VCR accordingly.
Table 1
REC SPEED setting
6 (6H)
18 (18H)
30 (30H)
40
(GB)
Recording speed setting
on the real time VCR
8H (8-hour mode)
24H (24-hour mode)
40H (40-hour mode)
ALARM REC SPEED
With a timelapse VCR
Set the recording speed to use when an alarm trigger is
received to match the alarm recording speed of the
timelapse VCR.
The available speeds are:
3 (3H) (Default setting), 12 (12H), 24 (24H), NC,
F3
NC: When an alarm trigger is received, the recording
speed is not changed and stays as set under "REC
SPEED".
F3: Use this setting when using the SW output
terminal on a timelapse VCR that does not output
a switching signal in 3H mode.
With a real time VCR
Set the recording speed to use when an alarm trigger is
received to match the alarm recording speed of the real
time VCR.
The available speeds are:
6 (6H) (Default setting), 18 (18H), NC, F6
NC: When an alarm trigger is received, the recording
speed is not changed and stays as set under "REC
SPEED".
F6: Use this setting when using the SW output
terminal on a real time VCR that does not output a
switching signal in 6H mode.
If the VCR is Equipped with an SW (switching)
Output Connector (using the VCR switching
signal)
Make the connection from this unit to the VCR SW
output connector. The video signal output by this unit
will be automatically switched to the recording speed
according to the switching signal output by the VCR
(switching pulse setting on the VCR).
The (VCR SET) menu "REC SPEED" and "ALARM
REC SPEED" items do not need to be set.