Sony YS-DX516P Bedienungsanleitung Seite 55

3
Set the video sensor area position. Using the V, v,
b and B buttons, move the cursor to the desired
position according to the picture in the
background.
4
Using the + (or –) button, set A or B for the
selected point.
Every time the + button is pressed, the setting will
change as follows:
A t B t - t A...
Repeat steps 3 and 4 to set all the desired video
sensor points of the desired area(s).
• Set the desired point(s) to setting A or B.
• "-" indicates a sensor point without any setting
(there are 10 lines of 16 points each), that is not
used as video sensor.
• To erase a line of video sensor points (A or B),
move the cursor to the line to erase, then press the
MENU RESET button.
4. Sensor point not used
(LEVEL DAY)
5. Sensitivity level for the
day period (ex.:8)
(LEVEL NIGHT)
5. Sensitivity level
for the night
period (ex.: 10)
5
Set the sensor sensitivity level. Using the V (or v)
button highlight the "LEVEL DAY" setting.
Press the b button, then using the + (or –) button
set the desired sensitivity level for the "DAY"
period.
Follow the same procedure to set the desired
sensitivity level for the "NIGHT" period.
The available sensitivity levels are: OFF (Default
setting), 1, 2, 3...10 (10 being the least sensitive,
default setting).
4. Sensor point A
4. Sensor point B
(MODE)
6. Sensor response mode
Note
The sensor sensitivity level can only be checked
for the time of the setting. (i.e., the night level
setting cannot be checked during the day.)
6
Set the sensor response mode.
Press the b button to highlight the "MODE"
setting. Using the + (or –) button set the desired
mode.
• MODE A (default setting):
The video sensor will send a trigger when it
detects movement at the video sensor area points
A.
• MODE A AND B:
Set points A and points B at a predetermined
distance, so that only large subjects, that are
detected by both video sensor points
simultaneously send an alarm trigger. Smaller
objects that are detected only by one set of video
sensor points at the time will not send an alarm
trigger.
• MODE A AND NB (Fig. 1):
Set the video sensor points A at the centre of the
main area, and video sensor points B at the
periphery, where no movement will be detected.
A trigger will be sent when change is only
detected at the video sensor points A, not at the
video sensor points B. For example, if the whole
screen (A and B) brightness changes due to a
change in lighting or sunrays, a trigger is not sent.
But, if a change is detected only at the centre of
the screen (A), a trigger is sent.
Fig. 1
(Continued)
55
(GB)