Basic Operations; Mode Switching - Sony YS-DX516P Bedienungsanleitung

Basic Operations

Mode Switching

When the ON/STANDBY button is pressed, the
default display mode will be as follows: live picture
displayed in a 16 divisions split screen on monitor 1,
and sequentially, full screen on monitor 2. You can use
the VCR, MENU and LIVE buttons to switch to the
LIVE picture mode
Live Picture Mode (see page 20 (GB))
When the LIVE button is pressed, the live (direct)
picture from the cameras connected to the camera
input terminals (1 – 16) on the unit rear panel, will be
displayed on monitor 1.
Notes
• The unit will automatically start in the live picture or
VCR playback display mode (16, 9, 4 divisions split
screen, full screen or sequential display) last selected.
Therefore, when a mode is selected, the display mode
will remain the same.
• If a camera is not connected at one of the input
terminals, "NO VIDEO" will be displayed on the
monitor 1 screen.
desired mode on monitor 1 (see below for further
information). When the power is restored after having
already used the unit, the unit will restart in the modes
selected before the unit was turned off.
VCR playback mode
VCR Playback Mode (see page 28 (GB))
Start playback on the VCR. If the video signal is
correctly recorded, the VCR playback image will be
displayed on monitor 1 when the VCR button is
pressed.
Notes
• If playing back a tape not recorded through this unit,
"NO ID" will be displayed on the monitor screen.
• In live picture mode and VCR playback mode there
may be a slight vertical roll of the picture.
LIVE picture mode Menu mode
17
(GB)