Calling Up Programs; Write Protection For Programs; Program Linkage; Activating Or Deactivating Program Linkage - Hettich ROTANTA 460 Bedienungsanleitung

EN
16.2

Calling up programs

•
Press the key. The parameters RCL is displayed.
PROG
•
Use the adjusting knob
If a "+" is shown after the program location, then this data is write-protected.
•
Press the key. Briefly, Program recall ... is displayed as confirmation.
START
The centrifugation data of the selected program place is shown.
16.3

Write protection for programs

The programs can be protected against unintentional modification.
The write protection can be activated/deactivated as follows when the rotor is at a standstill:
•
Call up the desired program (see the chapter on "Calling up programs").
•
Press the key. The parameters RCL is displayed.
PROG
•
Press and hold the
PROG
After eight seconds, Set Protection = 1- (for example) appears in the display.
•
Set "+" or "-" with the adjusting knob.
+ = program is write-protected,
- = program is not write-protected.
•
Press the button to save the setting.
START
16.4

Program linkage

"Program linkage" can be used to link several centrifuge operations together.
A program linkage is only possible if this has been activated (parameter Multi programs = on; see the
chapter on "Activating or deactivating program linkage").
16.4.1

Activating or deactivating program linkage

The program link can be activated/deactivated as follows when the rotor is at a standstill:
•
Press and hold the
PROG
After eight seconds, ∗∗∗ Machine Menu ∗∗∗ appears in the display.
•
Press the key as often as necessary until the ->Settings is displayed.
PROG
•
Press the key. The SOUND / BELL = off/on is displayed.
START
•
Press the key as often as necessary until the Multi programs = off/on is displayed.
PROG
•
Set off or on with the adjusting knob
off = program linkage deactivated,
on = program linkage activated.
•
Press the key to save the setting.
START
Briefly, Store Settings ... is displayed as confirmation, followed by -> Settings.
•
Press the key once to leave the "Settings" menu or press the
OPEN / STOP
"Machine Menu".
44/147
to set the program place you want.
button for eight seconds.
button for eight seconds.
.
key twice to leave the
OPEN / STOP