Installing The Rotor - HBM t40 Montageanleitung

T40

3.4 Installing the rotor

NOTE
In general, the rotor identification plate is no longer visible after
installation. This is why we include with the rotor additional stickers
with the important ratings, which you can attach to the stator or any
other relevant test bench components. You can then refer to them
whenever there is anything you wish to know, such as the shunt signal.
To explicitly assign the data, the identification number and the
measuring range are engraved on the rotor flange, where they can be
seen from outside.
Fig. 3.1: Rotor of the T40 torque flange
1. Prior to installation, clean the measurement flange's and counter flanges'
plane surfaces. For safe torque transfer, the surfaces must be clean and
free from grease. Use a piece of cloth or paper soaked in solvent. When
cleaning, make sure that you do not damage the transmitter winding.
2. For the bolted rotor connection, use eight DIN EN ISO 4762 property class
according to Table 3.1 hexagon socket screws of a suitable length
(dependent on the connection geometry).
We recommend fillisterhead screws DIN EN ISO 4762 or similar,
blackened, smoothheaded, permitted size and shape variance in
accordance with DIN ISO 4759, Part 1, product class A.
A2463 5.0 en/de
Transmitter winding (covered)
13
Flange plane face
HBM