Safety Instructions - HBM t40 Montageanleitung

4
T40

Safety instructions

Appropriate use
T40 torque flanges are used exclusively for torque, rotation speed, angle of
rotation and power measurement tasks and control and adjustment tasks
directly connected thereto. Use for any additional purpose shall be deemed to
be not as intended.
Stator operation is only permitted with an installed rotor.
In the interests of safety, the transducer should only be operated as described
in the Operating Manual. It is also essential to comply with the legal and
safety requirements for the application concerned during use. The same
applies to the use of accessories.
The transducer is not a safety element within the meaning of its use as
intended. Proper and safe operation of this transducer requires proper
transportation, correct storage, assembly and mounting and careful operation.
General dangers of failing to follow the safety instructions
The transducer corresponds to the state of the art and is failsafe. The
transducer can give rise to remaining dangers if it is inappropriately installed
and operated by untrained personnel.
Everyone involved with siting, starting up, maintaining or repairing the
transducer must have read and understood the Operating Manual and in
particular the technical safety instructions.
Remaining dangers
The scope of supply and performance of the transducer covers only a small
area of torque measurement technology. In addition, equipment planners,
installers and operators should plan, implement and respond to the safety
engineering considerations of torque measurement technology in such a way
as to minimize remaining dangers. Prevailing regulations must be complied
with at all times. Reference must be made to remaining dangers connected
with torque measurement technology.
HBM
A2463 5.0 en/de