HBM t40 Montageanleitung Seite 15

T40
Antenna segment bolts with
washers (M5)
Fig. 3.2: Bolted antenna segment connections on the stator
Fig. 3.3: Stator housing and lower antenna segment with antenna wire
1. Undo and remove the bolted connections (M5) on the upper antenna
segment. There are fan type lock washers between the antenna
segments. Make sure that they do not get lost.
2. Use an appropriate base plate to install the stator housing in the shaft train
so that there is sufficient possibility for horizontal and vertical adjustments.
Do not yet fully tighten the bolts.
3. Now use two hexagon socket screws to mount the upper antenna segment
removed in 1. on the lower antenna segment. Make sure that the two fan type
A2463 5.0 en/de
Fan type lock washers
lower antenna segment
Stator housing
Hole ∅ 4.2 mm
for fixing the antenna
segment
upper
antenna segments
lower
Stator housing
Antenna wire
15
HBM