68
R AMP
L o- end =
H i- end =
T ravel =
D well =
MO D E
D IR E C T
S TE P
R AMP
S C AL E
+ 000.000 mV
+ 010.000 mV
0060 S ec
0005 S ec
S S S S S pecial Output Functions
pecial Output Functions
pecial Output Functions
pecial Output Functions
pecial Output Functions
Automatic Ramp
Automatic Ramp
Automatic Ramp
Automatic Ramp
Automatic Ramp
Mode
Mode
Mode
Mode
Mode
Ramp Mode
Ramp Mode
Ramp Mode
Ramp Mode
Ramp Mode
The MCX can generate automatically a
time linear increasing or decreasing
output signal. Signal limits are free to
set within any of the available output
ranges. Time scales can be set between
1 and 9999 seconds.
NOTE: The automatic ramp mode
cannot be used together with the
frequency measurement mode and
the pulse count mode.
Setting up the ramp mode
Setting up the ramp mode
Setting up the ramp mode
Setting up the ramp mode
Setting up the ramp mode
Select RAMP and fill out the set up
screen. The high-end value sets the
maximum output. The low-end value
sets the minimum output. Fill out the
desired travel and dwell time in seconds
and press EXE.
To start/stop a 'one shot' ramp
To start/stop a 'one shot' ramp
To start/stop a 'one shot' ramp
To start/stop a 'one shot' ramp
To start/stop a 'one shot' ramp
Press
to start a one shot ramp for
#
signal increase and press
ramp for signal decrease.
Press
and
simultaneously to
&
%
'freeze' the ramp action.
To restart press
or
#
cancel the ramping operation.
to start this
$
. Press CE to
$