58
Air probe
To simulate a thermocouple
To simulate a thermocouple
To simulate a thermocouple
To simulate a thermocouple
To simulate a thermocouple
• Hand held thermometer
(not supplied by Unomat)
Read the thermometer while holding it
close to the instrument terminals.
Select MANUAL and open the screen
to fill out the obtained reading. Press
EXE to enter.
Note that in this mode temperature
changes at the instrument terminals
can easily create calibrations errors.
• Remote temperature probe
(optional)
Plug-in the Pt100 probe as shown and
select PROBE in the right hand menu.
Position the sensor tip as close as
practically possible to the
instrument terminals.