Pulse Output Modes - GE Sensing MCX Bedienungsanleitung

52
Pulse output
Impulse Ausgang
Génération d'impulsions
Output of electrical signals Output of electrical signals Output of electrical signals
Output of electrical signals Output of electrical signals

Pulse output modes

Pulse output modes Pulse output modes
Pulse output modes Pulse output modes
Pulses are symmetrical square wave
and -70 mV zero based. Frequency is
set by the and keys or numerical
# $
keypad. Amplitude can be adjusted with
the and keys between
& %
0 and 24 Volts. Resolution is 0.1 Volt
and amplitude is default set to
5.0 Volts.With frequency set at 0 Hz this
function becomes available as a voltage
adjustable and regulated DC supply.
Frequency output can take loads up to
34 mA at 24 Volts maximum.
Pulse output range 0-100 Hz
Go to pulse DIRECT mode to output any
pulse signal between zero and 100 Hz.
Adjustments are made with
0.01 Hz resolution.
Pulse output range 0-10 kHz
Go to pulse DIRECT mode to output any
pulse signal between zero and 10.000
Hz. Adjustments are made with
1 Hz resolution.
Pulse output range 0-6000 P./Min.
Same as 0-100 Hz but reads in
Pulses/Minute