Changing The Output Level; Millivolts - GE Sensing MCX Bedienungsanleitung

48
+ 800.000
O U TS ID E R AN G E
C H E C K L O O P
+ 100.000
Use the
output signal manually. Holding the
key down will gradually accelerate
S E T
the adjustment speed.
mV
Enter a new output value through the
numerical keypad and press EXE to
activate the signal at the output
terminals. Entered values outside the
range will prompt the message
OUTSIDE RANGE.
Go to millivolts in the DIRECT mode to
output any signal between -10 mV and
100 mV. Adjustments are made with
O U T
1 microvolt resolution.
If the adjusted output level can not be
mV
maintained the screen will prompt the
warning CHECK LOOP.
Millivolts output
Millivolt Geben
Sortie millivolts
Output of electrical signals Output of electrical signals Output of electrical signals
Output of electrical signals Output of electrical signals

Changing the output level

Changing the output level Changing the output level Changing the output level Changing the output level
and keys to ramp the
# $

Millivolts

Millivolts Millivolts Millivolts Millivolts
NOTE: 'Terminal to test lead'
junctions may create e.m.f.
microvolts causing an offset in
the actual output signal.