Changing From Alkaline To Rechargeable Batteries; Recharging - GE Sensing MCX Bedienungsanleitung

22
Power Sources Power Sources Power Sources
Power Sources Power Sources
Changing from Alkaline to Changing from Alkaline to
Changing from Alkaline to Changing from Alkaline to Changing from Alkaline to
Rechargeable batteries Rechargeable batteries Rechargeable batteries Rechargeable batteries Rechargeable batteries
Remove the Alkaline batteries. Remove
the switch protector sticker and slide the
switch to the "Ni-Cd" position.
Place a new protector sticker to save
the new switch position. Install
6 rechargeable batteries (purchased
locally). Battery switch position will be
confirmed on the screen during start-up
of the calibrator. Recharge batteries
when the screen shows the blinking
battery symbol.
WARNING: Never place alkaline
or other non-rechargeable
batteries after you have changed
the switch position to "Ni-Cd".

Recharging

Recharging Recharging Recharging Recharging
Use the Line Adaptor/Charger #13603
only; other equipment may cause damage
to the calibrator. Check the indicated line
volt switch in the CHARGE position.
Connect the appropriate Adaptor/Charger
plugs to the line and to the calibrator. The
amber led CHG at the calibrator power
panel will now be on. As adaptor and
charger functions are fully independent
from each other, the calibrator can be
used while charging. Recharging time
from complete discharge to fully charge is
14 hours.