Volts; Milliamps/Xmtr - GE Sensing MCX Bedienungsanleitung

50
Transmitter (XMTR) Simulation
Simulieren 2-Leiter Transmitter
Simuler un transmitter 2-fils
Go to Volts in the DIRECT mode to
Volts output
output any signal between zero and 12
Volt Geben
Volts. Adjustments are made with 100
Sortie volt
microvolts If the adjusted output level
can not be maintained the screen will
prompt the warning CHECK LOOP.
Use mA terminals to source a current
into a resistor (active mode). Use
XMTR terminals to simulate a 2-wire
transmitter (passive mode). Go to
milliamps in the DIRECT mode to
output any signal between 0 and
24 mA. Adjustments are made with
1 microamps resolution. If the
adjusted output level can not be
maintained the screen will prompt the
warning CHECK LOOP. To output
fixed 0, 4, 8, 12, 16 and 20 mA levels,
press
Use
mA output
mA Geben
current. Press
Sortie mA
normal output mode.
Output of electrical signals Output of electrical signals Output of electrical signals
Output of electrical signals Output of electrical signals

Volts

Volts
Volts Volts Volts

Milliamps/XMTR

Milliamps/XMTR Milliamps/XMTR
Milliamps/XMTR Milliamps/XMTR
key to change to fixed steps.
%
and keys to adjust the output
# $
key to return to
&
mA / XMTR
20.000
+ 100.00% S TE P : 06
S E T S E T
mA