GE Sensing MCX Bedienungsanleitung Seite 3

Set mode ............................................ 46
Output mode ....................................... 46
Changing the output level ................. 48
Millivolts .............................................. 48
Volts .................................................... 50
Milliamps/XMTR ................................. 50
Pulse output modes ........................... 52
To simulate a thermocouple
Using compensation wires ................ 56
Using the standard test leads .......... 56
To simulate a RTD or a resistor
RTD Simulation .................................. 60
Resistor Simulation ........................... 60
Special Output Functions:
Step Mode
Setting up programmable steps ....... 64
Setting up 10%, 20% or 25%
division steps ..................................... 64
To output fixed steps manually ........ 66
To output fixed steps automatically . 66
Automatic Ramp Mode
Ramp mode ........................................ 68
Setting up the ramp mode ................ 68
To start/stop a 'one shot' ramp ........ 68
To start/stop ramp cycling ................ 70
Scaled readings
Setting up scaled readings
(linear relationship) ........................... 72
Setting up scaled reading
(flow relationship) .............................. 72
Output in scaled readings ................. 74
Measurements in scaled readings ... 74
Transmitter calibration
Setting up a calibration ..................... 76
To check or calibrate a transmitter .. 76
Temperature transmitter simulation
Setting up a simulation ...................... 78
To simulate a transmitter .................. 78
To measure electrical signals
Millivolts .............................................. 80
Volts .................................................... 80
Milliamps/XMTR ................................. 80
Ohms .................................................. 82
Frequency ........................................... 82
Pulse Counter .................................... 84
Switch position change ..................... 86
Circuit continuity tester ..................... 86
To measure temperatures
With thermocouples .......................... 88
With RTD'S ........................................ 88
With the remote probe (optional) ..... 90
Programmable signal converter
Setting up a signal converter ............ 92
User power supplies ........................... 94
CE Remarks .......................................... 96
Service, Repair and Parts Service, Repair and Parts
Service, Repair and Parts Service, Repair and Parts Service, Repair and Parts
Recalibration of the MCX ................... 98
Fault finding procedures ................. 104
Spare parts list .................................. 112
Lithium cell replacement and
Software updates .............................. 112
Specifications .................................... 116
Protocol for RS232 system
integration .......................................... 128
To measure pressures (optional)
Read pressure module MCX-PM
operation manual
Automatic calibration or testing
(optional)
Read Linkpak-W operation manual
To communicate with 'smart'
instrumentation (optional)
Read " communicator " operation
manual
3