Priming Menu - DAB E.SWIM Installations- Und Wartungsanleitungen

OUTPUT
STATUS
Useful page for verifying the correct
functioning of the connections.

5.5 PRIMING Menu

PRIMING
Each time the pump starts, the system performs the priming procedure (if enabled).
Priming consists of two phases:
- At the end of pump startup (as described in par. 3.2), the flow is checked; if it regular, Priming has already been
completed and it passes to the conditions of the active setpoint.
- If this is not the case, the system has discharged and must be primed again: it now enters the second phase, where
the pump is activated at Priming Speed, until it is primed or at any rate for all the Priming time
ENGLISH
PARAMETERS VALUES
Config
RUN
FAULT
NOTE: NC or NO depends on the connection.
For the version with 5Pin connector the contact type
is chosen, whether NO or NC
PARAMETERS DESCRIPTION
IN-0 Status of the digital Input
OUT Output relay status
AN Status of the Analog Input
AP ext Value of the enabled External Speed
IN1-4 Status of the digital inputs
PARAMETERS VALUES
Enable Yes/No
Speed 50%-100%
Time 1-30 min
66
DESCRIPTION
The relay signals when the pump is
working
The relay signals when the pump
fails
DESCRIPTION
Enables or disables the Priming
function that occurs at each start.
It is usually disabled in
installations below water level.
Sets the maximum speed during
priming, which can be reduced in
the case of systems unable to
withstand high speeds.
Sets the duration time in the
priming phase.
At the end of this time, if priming
has been successful, it proceeds
regularly according to the active
setpoint. But if priming has not
been successful, it goes into
"NoPriming" fault status ("Pump
not primed" block). See chapter 6.