Control With Timers - DAB E.SWIM Installations- Und Wartungsanleitungen

QUICK CLEAN
The "QuickClean" key allows you to perform a rapid wash of the system or fast recirculation, for example by
cleaning, suction, adding chemicals, and so on.

5.3 Control with Timers

TIMER CONTROL
This menu allows you to set the automatic filtration cycles of the electronic pump. The parameters related to the
different speeds (S5-8), the start and stop times of each cycle (up to 8 cycles: A-H) and the day of the week are set.
In addition, from the "Preset Timers" menu, you can select an already set basic filtration cycle from which to start to
configure the most suitable cycle for your needs.
SPEED WITH TIMERS
This menu items allows you to view and change the parameters associated with the speeds from 5 to 8 managed by
the timers.
SETTING OF THE TIMERS
There are eight different timers on the machine, from Timer A to Timer H, each of which allows timed starting and
stopping, on a weekly basis, of a setpoint chosen from Set Points 5-8.
With a simple setting you can thus automatically carry out all the desired cycles, repeated weekly.
Another special function is available: holding down "Enter" [
which you are positioned; moving to another timer and holding down "OK" [
ENGLISH
PARAMETERS VALUES
Speed 20% - 100%
TIme 1 min - 10 h
PARAMETERS VALUES
Control Mode FLOW/SPEED
S5-S8 5 - 25 m3/h (o
20 - 110 GPM)
20% - 100%
The speeds from 5 to 8 cannot be loaded from the keyboard, but they
are activated and deactivated only by the TIMERS system. Unlike
speeds 1-4, they do not have any associated duration, as the activation
time is decided always and only by the TIMERS.
PARAMETERS
Enable Timer ("E")
the START time
the STOP time
Desired speed ("S")
Days of the week
] for three seconds makes a copy of the timer on
63
DESCRIPTION
Setting the speed with fixed curve
control (in percentage%)
Setting the duration time at the
relative speed.
The duration value indicates the
time that the speed remains
active, after which it ends.
DESCRIPTION
The first choice to make is whether
you want the setpoints "SET5-8" to
set the system regulation mode to
"Flow" or "Speed %".
Setting the speed with flow control.
Setting the speed with fixed curve
control (in percentage%)
VALUES
The possibility of enabling or disabling a timer
may be useful, for example, at the change of
season, allowing you to exclude a timer but
leaving all its data set to be used again later.
00:00 - 23:59
00:01 - 24:00
S5-S8
Lun / Dom
] for three seconds pastes the whole
DESCRIPTION
sets the time of
starting the work
cycle
sets the time of
ending the work
cycle
Selects one of the
4 speeds for the
set work cycle
You can enable
the work cycle for
the days of the
week you want