DAB E.SWIM Installations- Und Wartungsanleitungen Seite 67

SETTINGS
NOTE:
In case of Speed Mode = Priority, speeds X1-X4 are available.
In case of Speed Mode = Combination, speedsX1 is not available.
In case of Start Input = Speeds, X1 is not enabled and the combination 0 0 does not cause the pump to start.
INPUTS
ENGLISH
PARAMETERS VALUES
Config Disabled
Enabled
Override
Origin speed Digital IN
0-10 V
4-20mA
X1
E.ADAPT
Start Input IN-0
Speed
Speed Mode Priority
Combinations a speed according to table X is
PARAMETERS VALUES
IN0-IN4 Type NO
NC
65
DESCRIPTION
External Control Disabled
External Control enabled and
Timers A-H disabled
External Control enabled with
priority over the enabled Timers A-
H
Speed determined by the state of
the digital inputs.
Speeds determined by 0-10V
analog voltage signal (see chapter
2.5)
Speeds determined by 4-20 mA
analog current signal (see chapter
2.5)
The speed X1 set in the "External
Speeds" menu is implemented.
Speed determined by the status of
the inputs of the "E.ADAPT"
module
Starting of the pump is determined
by the status of input IN-0.
Pump starting determined by the
status of inputs IN1-4. Without
Each input is associated with a
speed (IN1 --> X1; IN2 --> X2;
etc.);
in the case of more than one
enabled input, the one with the
highest number
(IN4>IN3>IN2>IN1) has priority.
associated with each combination
of inputs IN1 and IN2
IN1 (0) + IN2 (0) --> SPEED (X1)
IN1 (1) + IN2 (0) --> SPEED (X2)
IN1 (0) + IN2 (1) --> SPEED (X3)
IN1 (1) + IN2 (1) --> SPEED (X4)
DESCRIPTION
Normally Open
Normally Closed