Machine Status Menu; Programming Menu - Eliwell EWPlus 902 Handbuch

IDPlus 961-974 -HC

MACHINE STATUS MENU

Press and release the
appears. Press and
set
Programming the setpoint: To view the Setpoint value, press the
Displaying the probes:

PROGRAMMING MENU

To access the "Programming" menu, press and hold the
activated, a prompt will appear: enter PA1 for "User" parameters or PA2 for "Installer" parameters (see "PASSWORD"
section).
‛User' parameters:
‛Installer' parameters:
NOTE: Switched off and then on again the device each time the configuration of the parameters is changed.
9IS54671.00 10 - 2018
key to access the "Machine Status" menu. If no alarms are active, the "SEt" label
set
to scroll through the folders in the menu:
- AL: alarms folder (only visible if alarms are active);
- SEt: Setpoint configuration folder;
- Pb1: probe 1 - Pb1 value folder;
- Pb2: probe 2 - Pb2* value folder (model IDPlus 974 -HC only);
- Pb3: probe 3 - Pb3 value folder **;
* folder displayed if Pb2 present (H42 = y)
** folder displayed if Pb3 present (H11 = 0 and H43 = y)
Setpoint value appears in the display. To change the Setpoint value, press the
and keys within 15 seconds. Press
When the label Pb1, Pb2 or Pb3 is displayed, press
value will appear (NOTE: the value cannot be changed).
When the menu is accessed, the display will show the first parameter (e.g. "diF"). Press
and to scroll through all parameters in the current level. Select the desired parameter
by pressing . Press
set
When the menu is accessed, the display will show the first folder e.g. "CP"). Press
to scroll through the current level folders. Select the desired folder using
and to scroll through the parameters in the current folder and select the parameter using
. Press and
set
key when the "SEt" label is displayed. The
set
set
key for at least 5 seconds. If PASSWORD protection is
set
and to change it and
to change it and to save the change.
set
to confirm the change.
and the associated probe
set
to save the change.
set
www.eliwell.com
and
. Press
set
18/40