Eliwell EWPlus 902 Handbuch Seite 38

IDPlus 961-974 -HC
PAR. Description
rEL Device version. Read-only parameter.
tAb table of parameters. Reserved: read-only parameter.
COPYCARD ("FPr" folder)
Upload. Transfer programming parameters from instrument to
UL
CopyCard/UNICARD.
Formatting. Deletion of data found on the
CopyCard/UNICARD.
Fr
NOTE: If parameter "Fr" is used, the data entered will be
permanently lost. This operation cannot be reversed.
FUNCTIONS (folder "FnC")
The following function is available inside folder "FnC":
Function
Reset pressure switch alarms
Reset HACCP alarms
NOTES: • To change the status of a given function, press the "SET" key.
• If the instrument is switched off, the function labels will return to the default status.
DISCLAIMER
This document is the exclusive property of Eliwell and cannot be reproduced or circulated unless expressly
authorized by Eliwell. All possible care has been taken to ensure the accuracy of this document; nevertheless,
Eliwell Controls srl cannot accept liability for any damage resulting from its use. The same applies to any person or
company involved in preparing and editing this document. Eliwell reserves the right to make aesthetic or functional
changes at any time without notice.
9IS54671.00 10 - 2018
Function label active Function label not active
rAP
rES
Range UM AP1 AP2 AP3 AP4
/ / /
/ / /
/ / /
/ / /
Alarm signaling
rAP LED ON
rES LED ON
www.eliwell.com
/ / /
/ / /
/ / /
/ / /
38/40