"Machine Status" Menu - Eliwell DR4000 series Handbuch

The following procedure is to be followed in order to set the 2 setpoint values in the device,
SEt1 and SEt2.
1
SET
Tun. S.Str out1 aux out2
1) Press and release
the 'set' key on the first
window of the display
(probe Pb1 value).

"MACHINE STATUS" MENU

2
SET
Tun. S.Str out1 aux
2) Label SEt1 is
shown on the PV
display, whiled the
current value of the
Setpoint is shown on
the SV display. Press
the 'set' key again,
the PV display will
blink and you can
edit the value on the
SV display.
3
out2 Tun. S.Str
3) Use the UP and
DOWN keys to
change the setpoint
value shown on the
SV display.
4
FNC
SET
Tun.
out1 aux out2
4) When the 'set' or
"fnc" key is pressed,
or after timeout
(15 sec), the new
value appears and
the initial screen
is restored on the
display.
S.Str out1 aux out2