Machine Status Menu; Programming Menu - Eliwell ICPlus 902/A Bedienungsanleitung

Access the Machine Status menu by pressing
Use the keys and to scroll through all the folders in the menu:
Setting the Setpoint:
Displaying probes:
To access the 'Programming' menu, press the
User parameters and 'PA2' for Installer parameters (see 'PASSWORD' paragraph).
User Parameter: When accessed, the display will show the first parameter (e.g. 'dF1'). Press
the current level. Select the desired parameter by pressing
Installer Parameter: When accessed, the display will show the first folder (e.g. 'rE1'). Press
current level. Select the desired folder using
parameter using . Press
NOTE: Make sure you switch the instrument off and on again each time the parameter configuration is changed, in order to prevent
malfunctioning in the configuration and/or timing in progress.

MACHINE STATUS MENU

and releasing the key. If no alarms are active, the 'SP1' label appears.
To display the Setpoint value press the
The Setpoint value appears on the display. To change the Setpoint value, press the
seconds. Press to confirm the modification.
When label Pb1 is present, press the
(NOTE: the value cannot be modified).

PROGRAMMING MENU

key for more than 5 seconds. If specified, an access PASSWORD will be requested: 'PA1' for
. Press
and to modify it and
- AL: alarms folder (only visible if an alarm is active);
- SP1: Setpoint 1 setting folder;
- Pb1:
probe 1 - Pb1 folder;
key when the 'SP1' label is displayed.
key to view the value measured by the corresponding probe
. Press and to modify it and
and to scroll through the parameters in the current folder and select the
to save the changes.
13
and
and to scroll through all the parameters on
to save the changes.
and to scroll through the folders on the
keys within 15