C) Installing The Main Landing Gear; D) Installing The Flight Accumulator - Reely 1542912 Bedienungsanleitung

c) Installing the main landing gear

• The main landing gear (1) is slid from below into the
prepared shaft on the bottom of the fuselage (2).
• To do so, press the two wheels slightly together and
slide the wire into the shaft.
• Then you can let the wheels spring back. The landing
gear is then safely suspended in the shaft by the spring
force of the wire.

d) Installing the flight accumulator

• You have to take off the cabin hood (1) to insert the flight
accumulator. To do so, press the latch (2) forward and
lift the hood off forward on the front.
• The hood is maintained in place in the rear by another
latch that snaps in beneath the fuselage wall.
When putting on the hood, you first have to
slide in the catch beneath the side wall of the
fuselage before securing the hood again with
the front latch.
• Prior to connecting the accumulator to the model, you
have to check whether the function switch on the model
(3) is in the rear position (OFF).
• Insert the charged flight battery (4) into the battery com-
partment and connect it with the plug-type connection
(5) of the flight control.
• Once again, the latches of the flight control plug must
engage in the groove of the accumulator plug the same
way as with connection to the charger.
Our tip:
Generally, it is not required to additionally se-
cure the flight battery in the model, because
the battery is retained by the fuselage parts. If
these clamps slacken over the course of time,
you can attach the flight battery with a bit of Vel-
cro tape or rubber rings.
42
Figure 7
Figure 8