SSS Siedle DCA 650-02 Programmieranleitung Seite 151

Changing service functions
- Default status
Changing service functions
In this menu, it is possible to set
the basic status, to define door
call acceptance with DTMF dialling
numbers 0-9, to switch the service
handset on/off for door calls and
check call button assignments.
If you wish to change service
functions, press the programming
button to confirm.
Default status
Here, it is possible to reset the
DCA 650-... to its as-delivered
status.
Press the programming button to
allow you to change to the Default
status.
Use the scroll buttons to change
between Default status „Yes" and
„No". Pressing the programming
button confirms your setting and
returns you at the same time to the
start of menu point 5.1.
Use the scroll button to move on to
menu point 5.2
Initialization
The initialization described in the
following is only necessary if this is
requested when programming in
the display.
Leave the system unchanged and
switch off the power. Press the
"Prog-Mod" button at the BNG/
BVNG 650-... and hold it down.
Switch on the power and do not
release the Prog Mod button until
after the flashing frequency of the
LED in the BNG/BVNG 650-... has
clearly slowed down (after 3-4 secs.).
This completely empties the memory
of the BNG/BVNG and re-initializes
the system.
5
Service function
change with
OK
5.1
Default status
change with
OK
Default status
No
OK
Default status
change with
Display
<OK>
Press the programming button
Display
<OK>
Press the programming button
Display
<OK>
Press the scroll button
Press the programming button
Display
<OK>
35