SSS Siedle DCA 650-02 Programmieranleitung Seite 133

Public network parameters
- public network line code
Public network parameters
In the public network parameters
submenu, the public network line
code, the delay time when lifting the
receiver (Pause off hook)
Public network line code
The public network line code
depends on the TC system and can
differ with different manufacturers.
This number is used to connect to
the public network. We have set
the number „0" in the factory,
as this is frequently used in many
systems. However, if required any
number from 0 to 9 as well as * or #
can be set.
Press the programming button to be
able to change the public network
parameters.
Press the programming button to be
able to change the public network
line code for TC system 1.
Using the scroll button, change to
the code you wish to use.
Press the programming button in
order to save the displayed code
number.
Using the scroll buttons, move to
the public network line code for the
2nd telephone system (TCS), which
can be operated as a subsystem to
TCS 1.
Should you wish to dial from the
DCA via TC system 1 and 2 into
the public network, here, too, you
will have to define a second public
network line code (as described
above).
After you have defined the 2nd
public network line code if required,
scroll to the next submenu using the
scroll button.
and the start of the dialling process
of the DCA 650-... operated at the
TC system and call acceptance of the
DCA 650-... are set.
1.3
Publ.nwk param.
change with
OK
Ext. line
change with
OK
Ext. line
0 (0-9.*,#)
OK
Ext. line
change with
Ext. line
change with
Pause off hook
change with
Display
<OK>
Press the programming button
Display
TCS 1
<OK>
Press the programming button
Display
TCS 1
<OK>
Go on pressing the scroll button
until the required public network
line code is displayed
Press the programming button
Display
TCS 1
<OK>
Press the scroll button
Display
TCS 2
<OK>
Press the scroll button
Display
<OK>
17