SSS Siedle DCA 650-02 Programmieranleitung Seite 144

Dialling using display call module DRM 611-...
Using the programming button,
confirm the current status of the DL
With the BTS/BTC receiver at the
DCA 650-... in position, a speech
connection exists to the active BTLM.
At this DRM 611-... , now select
the name you wish to program, i.e.
assign to a call number at the
DCA 650-... .
After selecting the name, the display
of the DCA 650-... changes.
The direct call number is a telephone
number which is dialled when a
door call is made to the relevant user
(in this case user 1). Max. 22 digits,
optional numbers 0 - 9, *, # and F
(flash function only possible before
the 1st digit of the call number)
Using the programming button,
confirm the direct call number.
Program additional users.
The assignment of additional users
is repeated until all users entered
in the DRM 611-... have been
programmed.
Terminate the programming session
by pressing the Prog mode button at
the BNG/BVNG 650-...
28
OK
Assign call button
for user
Direct call no.
_ <OK>
OK
Doorloudspeaker
active? <OK>
OK
Assign call button
for user
Press the programming button
Display
1
The name you wish to program at
the DCA 650 is selected using the
buttons < and >. Then confirm your
selection with the bell symbol. This
is confirmed with the acknowledge-
ment tone.
Enter the call number you wish to
1
be dialled when selecting the name
from the DCA 650-... .
Press the scroll buttons to select the
number and the cursor button to
switch to the next number.
Press the programming button to
confirm your input.
Terminate the programming session
by pressing the Prog button at the
BNG/BVNG 650-... or programming
additional users.
Display flashes!
Press the programming button to
confirm the input.
Select additional names at the
DRM 611-... , confirm your input
2
with the bell symbol button. A
confirmation tone is audible at the
DRM 611-... .