SSS Siedle DCA 650-02 Programmieranleitung Seite 120

Brief instructions for fast
commissioning and programming
Fast and error-free programming
of DCA 650-02
• Connect the DCA to an analogue,
unoccupied PBX extension.
This PBX extension must have
multiple-frequency dialling
capability, in particular during an
internal connection within the TC
system.
• Ensure that there is no direct
public network connection program-
med at the relevant PBX extension
on which the DCA is operated (auto-
matic engagement of the public net-
work line when the receiver is picked
up). If necessary, cancel this function
in the TC system programming.
• The PBX extension must be
programmed as a telephone (not as
a fax, answering machine or door
intercom, etc.).
• If you want the DCA to call several
telephones at the same time, the
TC system must be programmed
for this function (known as group
call, collective call, etc.). For further
information, see the documentation
for the TC system.
• It is not admissible to program
collective call reception entitlement
for the PBX extension to which the
DCA is assigned.
• If you wish the DCA to receive
calls, the call acceptance function
must be activated when program-
ming the DCA (menu system
configuration, public network
parameters, call acceptance). Entitle-
ment to receive public network calls
must then be programmed out for
the DCA connection within the TC
system, or a separate number must
be issued for the DCA.
As-delivered status
• Call signal time 40 secs.
• Max. speech time 3 mins.
• Chain call time 20 secs.
• Call acceptance - none
• Config. PIN 0000 (i.e. no PIN
active)
• Code for external line - 0
• Pause after external line - 1 sec.
4
DCA 650-02
S. SIEDLE & SÖHNE
OK
Sprache/Language
ändern/Change with
Register new
user with
OK
Register user
Please wait
No. of new users
03 new users
OK
Registr. running
03 new users
Switch on prog.
mode at BNG/BVNG
Doorloudspeaker
actively
Doorloudspeaker
enable
OK
V 2.x
Press the OK button
<OK>
Press the cursor button until you
reach the next display
<OK>
Confirm with the OK button
Please wait until the DCA 650-...
has checked the connected In-
<OK>
Home-bus system, then the display
changes automatically to:
<OK>
Use the arrow buttons to define
the number of call destinations
you wish to be programmed. 1 call
destination = 1 user (BTS/BTC)
Confirm with the OK button
Please wait until the display stops
flashing and changes automatically
<OK>
to:
Press the programming button on
the BNG/BVNG 650-...
<OK>
The following display flashes.
Switch the door loudspeaker you
want to program to programming
<OK>
mode by pressing the light or pro-
gramming button (4 secs.).
The display stops flashing and you
can confirm the display with the OK
button.