SSS Siedle DCA 650-02 Programmieranleitung Seite 138

Registering new users
"Point A"
Using the programming button,
confirm the active status of the DL
With plugged-in telephone receiver
BTS/BTC at the DCA 650-..., a
speech connection exists to the
active doorloudspeaker, which is
beneficial during programming.
At this DL, the call button you wish
to assign to user 1 must now be
pressed for 4 secs (see programming
instructions BSG 650-...).
The direct call number is a telephone
number which is dialled when
making a direct door call to the
relevant user (in this case user 1).
Max. 22 digits, any number possible
between 0 - 9, *, #, and F (flash
function only in the 1st position
before the call no.).
Using the scroll buttons and the
cursor buttons, enter the required
direct call number.
Pressing the programming button
confirms the direct call number
and returns you automatically to
„Point A", in order to execute the
call number assignment for the next
user.
In case of parallel switching of a
BTS/BTC/BFS/BFC to a DCA 650-
... user
"Point A"
Use the programming button to
confirm the active status of the door
loudspeaker.
At the BTS/BTC BFS/BFC you
wish to program to the same
call button, pick up the receiver
and press the light button until
the call connection to the door is
established.
At the DL, then press the call button
you wish to assign as a user to
the DCA 650 and BTS/BTC for 4
seconds.
22
OK
Assign call btn.
for user
Direct call no.
_ <OK>
Direct call no.
_ <OK>
OK
Doorloudspeaker
active? <OK>
OK
Assign call btn.
for user
Direct call no.
_ <OK>
Press the programming button
Display
1
Hold down the call button for
4 secs. The display appears
automatically.
Display
1
Display
1
Press the scroll button to select the
number and cursor button to switch
to the next number.
Press the programming button
Display flashes!
Press the programming button
Press the light button at the
BTS/BTC/BFS/BFC for 4 secs.
1
Do not replace the receiver!
Hold down the call button for
1
4 secs. The display appears
automatically.