SSS Siedle DCA 650-02 Programmieranleitung Seite 129

PIN protection
- Extended functions PIN
Door parameters
Access the required number with the
scroll button and with the aid of the
cursor button move on to the next
number. Confirm with the program-
ming button and
Quit this submenu with the ESC
button.
Reach the next menu point using the
scroll button.
Door parameters
In this submenu point, the call
signalling time, the maximum speech
time to the door and the chain call
time are defined. In addition, it is
possible to assign the possibility of
Doormatic release.
If you do not wish to change any
of the door parameters, scroll on
through.
Using the programming button, in
the submenu 1.2 you first reach the
call signalling time, which is set at
the default time of 40 secs.
If the call button is actuated at the
door, the DCA 650-... forwards a
door call for the set time. During this
period, a speech connection can be
made by picking up the receiver.
Every new actuation of the button
restarts this call period, whereby
holding down the button does not
influence the function.
In case of an active chain call, this
time applies for the call to the 2nd
user. Hold down the programming
button in order to reach the setting
for the call time.
Access the required number using
the scroll buttons and index on to
the next number with the aid of the
cursor button.
Using the programming button,
confirm the set time and scroll on
through to the max. speech time.
OK
Extended PIN fct.
change with
Esc
PIN setting
change with
1.2
Door parameter
change with
OK
Call signal time
change with
Note: The call signal time cannot
be set with direct call acceptance
without DTMF!
OK
Call signal time
40s
OK
Press the scroll button / cursor
button as often as necessary until
the required PIN for the extended
functions has been entered.
Press the programming button
Display
<OK>
Press the escape button
Display
<OK>
Press the scroll button
Display
<OK>
Press the programming button
Display
<OK>
Press the programming button
Display
<OK>
Press the scroll button / cursor
button as often as necessary until
the required time is set.
The call signal time can be set
between 15 and 90 seconds.
Press the programming button
and scroll button.
13